98
Fig.12 Connecting drive unit
1. Reconnect two-pin Molex plug (4)
(4)
Fitting throttle
(continued)
Fig.13 Fitting drive unit
NOTE! When putting the drive
unit (2) in place, do not pinch,
bend or strain the cables.
1. Fit the drive unit (2) using two screws
(3)
(2)
(3)
Fig.14 Screws on the front aperture
1. Fit two screws (1) on front aperture
2. Fit side panel
3. Close wire-feed unit cover
(1)
To Next Page
Loading...
