97
EN
1. Fit throttle (14) using three screws
(13)
Fitting throttle
(continued)
1. Fasten throttle lead (9) - Fig.8 - onto
middle tap connection using screw
(12) - Fig.9.
2. Fit copper clips (11) and (10) as
shown in Fig.9
Fig.8 Fitting throttle
(13)
(13)
(14)
Fig.9 Connecting throttle
(11)
(10) (12)
1. Feed throttle lead (9) through shunt (8)
2. Push following components onto hexagon bolt (5):
- Lock washer (18)
- Spacer (19)
- Throttle lead cable lug (20)
- Star (21)
3. Tighten hexagon bolt (5)
(5)
(18)
(19)(20)
(21)
Fig. 11 Components on the minus socketFig.10 Fitting throttle lead
(5)
(6)
(8)(9)
(9)
(9)
To Next Page
Loading...
