Keypad Operations
This keypad supports a full menu mode which allows you to set or display the following information. Changed function code, operation monitor,
I/O check, maintenance information, and trip information For details, refer to the FRENIC-Mini Instruction Manual or User's Manual.
Keypad switches and functions
Monitor display and key operation The keypad modes are classified in the following 3 modes.
Monitor, keys
Programming mode
STOP RUN
Running mode
STOP RUN
Alarm mode
Operation mode
Function
Function
Function
Function
Function
Function
Display
Displays the function code or data code. Displays the output frequency, set frequency,
loaded motor speed, input power, output current,
output voltage, and motor speed.
Displays the trip content
or alarm history.
Switches to stop mode.
Switches to running mode.
Digit shift (cursor movement) in function
code/data setting
<Unit indication>
Frequency and speed: None
Output current: Output voltage:
Input power:
Releases the trip and
switches to stop mode.
Invalid Switches to running
mode (RUN).
Invalid Invalid
Invalid
Switches to programming
mode (STOP).
Switches to programming
mode (STOP).
Switches to programming
mode (RUN).
Invalid Switches to running
mode (STOP).
Invalid
Increases/decreases the function code number
and data code.
Increases/decreases the frequency, motor speed,
and line speed to be set.
Displays the alarm history.
Changes the display between function code and data
code, stores data code, and updates then function code.
Switches the LED monitor display.
Displays the operation
information.
ON
Blinking
ON Blinking/ON
MonitorKeys
LED monitor
When the motor is running or stopped:
The monitor displays the speed monitor (such as output
frequency before slip compensation, after slip compensation,
set frequency, motor speed, load shaft speed), output voltage,
output current, output voltage, and input power.
Alarm mode:
The monitor shows the cause of trip
with a fault code.
Program/Reset key
Used to change the mode.
Programming mode:
Used to shift the digit (cursor
movement) to set function codes or
data.
Alarm mode:
Resets a trip.
Function/Data select key
Used to change the LED monitor and to store
the function codes and data.
Run key
Used to start the operation.
While the motor is stopped:
This key is invalid if the function code is set to
(operation by external signals).
Potentiometer
Used to set the frequency, or
make auxiliary frequency setting
1, 2, and issue the PID process
commands.
Stop key
Used to stop the operation.
During operation:
This key is invalid if the function code is set to
(operation by external signals).
The inverter stops when the function code is set
to or .
Up/Down keys
During operation:
Used to increase or decrease the frequency or motor
speed.
In data setting:
Used to increase or decrease the function code number
or data set value.
16
To Next Page
Loading...
