The ideal functions to serve a multiplicity of needs for small-capacity inverters
A transistor output is provided.
This enables an overload early warning, lifetime forecast or
other information signals to be output during operation.
Compact
4.72
(120)
3.15(80) 3.15(80)
9.45(240)
(Units: inch(mm))
(Three-phase 230V, 1HP or less)
(Three-phase 230V, 1HP or less)
(Three-phase 230V, 2HP)
3.15(80)
FVR-C11S FRENIC-Mini
RS-485
communications card
Compatible with a wide range of
frequency settings
The optimum frequency setting method can be selected to
match your machine or equipment. Setting can be done by
keypad panel ( keys, potentiometer), analog input (4 to
20mA, 0 to +10V, 0 to 5V, 1 to 5V), multistep speed settings (8
steps) etc.
Two points can be set for a non-linear
V/f pattern.
One point for the non-linear V/f pattern, which can be set as
desired, has been added (making a total of 2 points), and so
the V/f pattern can be adjusted to match the application.
Side-by-side mounting is possible.
The output frequency can be set to a
maximum of 400Hz.
The inverter can be used for equipment that requires a high
motor speed such as centrifugal separator. In this case, check
the operation in combination with the motor.
RS485 communications card (option)
can be installed internally.
This card can be installed inside the inverter
,
s body without
changing the dimensions. RS-485 communications are
available as option.
A model with built-in braking resistor is
available on order.
For inverters of 2HP or larger, a built-in braking resistor type
can be selected.
Since installation and wiring of a separate braking resistor is
not required, the total mounting space is reduced.
Size interchangeability with Fuji
,
s
FVR-C11S series is provided.
Multiple inverter units can be mounted side-by-side inside a
panel. This features helps to minimize the space used for
installation. (Ambient temperature: 40°C (104°F) or less)
4
To Next Page
Loading...
