EasyManua.ls Logo

Fuji Electric UGx20 SERIES - Page 151

Fuji Electric UGx20 SERIES
275 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 - 82
1747-KE
Set up the parameters for 1747-KE, using the software specifically designed for this purpose.
DF1 Port Setup Menu
Baudrate : 19200
Bits Per Character : 8
Parity : Even
Stop Bits : 1
DF1 Full-Duplex Setup Parameters
Duplicate Packet Detection : Enabled
Checksum : BCC
Constant Carrier Detect : Disabled
Message Timeout : 400
Hardware Handshaking : Disabled
Embedded Response Detect : Auto Detect
ACK Timeout( 5ms) : 90
ENQuiry Retries : 3
NAK Received Retries : 3
Wiring
The following is a diagram to show the wiring of the cable which connects POD to PLC.
RS-232C
Wiring Diagram 1
D-sub 25pin(Male: )
FG
SD
RD
RS
CS
1
2
3
4
5
DCD
RXD
PLC
D-sub 9pin(Female: )
TXD
DTR
1
2
3
4
5
COM
DSR 6
7
8
RTS
CTS
SG 7
POD (CN1)
*
Use twist shielded cables.
27 Allen-Bradley PLC 2

Table of Contents

Related product manuals