Fuji Electric UGx20 SERIES - Connection and Settings for PLC Communication

Appendix-2
Connection
• Use each 1:1 communication cable when connecting the POD (CN1) to the PLC (CPU port).
• Use FUJI Electrics' UG00C-T cable when connecting the computer (PLC programming software) and
the POD(MJ1/2).
• When using the UG00S-CW editor and the PLC programming software:
When using two UG00C-T cables:
When the computer has two COM ports, use one port for the UG00S-CW editor and the other port
for the PLC programming software. Use the UG00C-T cables. (It is not possible to transfer the
UG00S-CW editor and the PLC programming software at the same time.)
When using one UG00C-T cable:
When using the UG00S-CW editor and the PLC programming software, it is not possible to use
one COM port for both purposes at the same time. Stop using both software for communications.
1:1 communication cable
MITSUBISHI QnH/FX series
MELSEC
CN1
CPU port
Computer (PC)
RESET
disc
GPPW
(UG00S-CW)
Communications between the comuputer and the PLC
Communications between the POD and the PLC
UG00C-T
MJ1/2
COM
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
UG20 series
POD
MELSEC
CN1
RESET
disc
UG00C-T
UG00C-T
MJ1
COM1
MJ2
COM2
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
POD
1:1 communication cable
MITSUBISHI QnH/FX series
CPU port
Computer (PC)
GPPW
(UG00S-CW)
UG20 series
Communications between the UG00S-CW and POD
Communications between the PLC programming
software and the PLC
Communications between POD and the PLC
UG00C-T
MELSEC
CN1
MJ1
RESET
disc
COM1
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
POD
1:1 communication cable
MITSUBISHI QnH/FX series
CPU port
Computer (PC)
GPPW
(UG00S-CW)
UG20 series