Fuji Electric UGx20 SERIES - Page 52

1 - 43
Main Menu
Main Menu
System Information
System Information
Screen Data
Information
Screen Data
Information
Size :
Size :
PLC Type: MITSUBISHIAnA/N/U series
Comment:
Error: Stop
Time-Out: 0.50 sec
Retry: 3
Connection: 1 : 1 Baud Rate: 19200
Signal Level: RS232C Data Length: 7
PLC Stat.No.: 0 Stop Bit: 1
Parity: Even
Send Delay: 0msec
SYSTEM PROG. VER.1.000
FONT
VER.1.000/1.000/1.000
JAPANESE 32
I/F DRV VER. 1.000
MELSEC AnA/N/U
1998- 9- 1 7 : 23 : 30
Editor : MJ1
Memory-Card
I/O Test
UG420H-TC1M1
786432
Own Stat.No.: 1
V6 Total: 2
Retry: 10
Multi-Link Network
Multi-Link Network
Setting of
comm. parameter
Font data version
System program version
Data size
Setting of modular jack
PLC type and comment
specified by the panel editor
Multi-link setting
*
This menu is displayed
only in case of selecting [1:1]
in [Connection] of [Comm. Parameter].
PLC I/F driver
version and name
ba
Model name of POD
17 Operation of POD Main Menu
Press the "Communication
Parameter" switch.
Multi-link setting
12:24:30
I/O Test
Communication
Parameter
Memory
-Card
Main Menu
Screen Data Size : 786432
Error : Stop
Time-out : 0.50 sec
Retry : 3
Editor:MJ1
Own Stat.No. : 1
V6 Total : 2
Retry : 10
Comm. Param.
Comm. Param.
Multi-Link Network
Multi-Link Network
Connection :
Signal Level :
PLC Stat. No.:
Baud Rate :
Data Length :
Stop Bit :
Parity :
Send Delay :
Multi-Link N
RS232C
00
19200
7
1
Even
20 msec
*
This menu is displayed
only in case of selecting
[1 : 1] in [Connection] of
[Comm. Parameter].
*
In case of UG221 and UG220, when the “Communication Parameter” switch on the “Main Menu” is
pressed, the following “Comm. Param.” is displayed.
1998- 7 -23 12:24:30
SYS PROG. VER. 0.591
FONT VER.1.000/1.010/1.000
JAPANESE 32
I/F DRV VER.1.000
MELSEC AnA/N/U
Editor:MJ1
Main Menu
Main Menu
PLC Type :
MITSUBISHI AnA/N/U series
Comment:
I/O Test
Communication
Parameter
Memory
-Card
UG220H-SC4
Font data version
System program version
Model name of
UG221/UG220
"Main Menu" of UG221/UG220
a
b
c
Setting of modular jack
PLC type and
comment specified
by the panel editor
PLC I/F driver
version and name