3 Copy
60
Copy
3
Copying Procedure
This section describes the basic copy procedures. The following shows the reference
section for each procedure.
Step 1 Loading Documents.........................................................................................................60
Step 2 Selecting Features ............................................................................................................62
Step 3 Entering a Quantity..........................................................................................................63
Step 4 Starting the Copy Job.......................................................................................................64
Step 5 Confirming the Copy Job in Job Status ...........................................................................65
Step 1 Loading Documents
The following two methods are available to load documents:
Document Feeder
z
Single sheet
z
Multiple sheets
Document Glass
z
Single sheet
z
Bound documents, such as books
Document Feeder
The document feeder supports single and multiple sheet documents with sizes from
125 x 85 mm (Standard size: A5, A5 ) to 216 x 356 mm (Standard size: A4, 8.5 x 11").
The document feeder automatically detects standard size documents. For non-
standard size documents, enter the size on the [Original Size] screen.
Note • The minimum supported paper size for 2-sided copying: 125 x 110mm (Standard size: A5,
A5 ).
For information on document sizes that can be detected automatically and how to enter a non-standard
document size, refer to "Original Size (Specifying the Scan Size for the Document)" (P.98).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on [Paper Size Settings], refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
The document feeder accepts the following number of sheets.
Important • To avoid paper jams, use the document glass for folded or wrinkled documents,
cut-and-pasted documents, curled paper, or back carbon paper.
• 2-sided scanning of lightweight paper (38 - 49 gsm) is not supported.
For information on how to copy mixed sized documents, refer to "Mixed Size Originals (Scanning
Different Size Documents Simultaneously)" (P.99).
1 Remove any paper clips and staples before loading a document.
Document Type (Weight)
Number of
Sheets
Lightweight paper (38 - 49 gsm) 110 sheets
Plain paper (50 - 80 gsm) 110 sheets
Heavyweight paper (81 - 128 gsm) 75 sheets
To Next Page
Loading...
