14 Problem Solving
478
Problem Solving
14
027-444
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 3] for IPv6 on the machine, or the IP address of
IPv6 on the network device, to remove the duplication of addresses.
027-445
[Cause] IP address for IPv6 set manually is incorrect.
[Remedy] Set the IP address correctly.
027-446
[Cause] The IP address of IPv6 set manually already exists.
[Remedy] Change the [Manually Configured IPv6 Address] on the machine, or the IP address of
IPv6 on the network device, to remove the duplication of addresses.
027-447
[Cause] The IP address of IPv6 network already exists.
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the IP address of IPv6 on
the network device, to remove the duplication of addresses.
027-452
[Cause] IP address of IPv4 already exists.
[Remedy] Change the IP address of IPv4 set on the machine or the IP address of IPv46 on the
network device.
027-500
[Cause] Unable to connect to the SMTP server.
[Remedy] Specify the SMTP server name correctly or specify the server by using its IP address.
027-501
[Cause] A POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
027-502
[Cause] Failed to log into the POP3 server when using the POP3 protocol.
[Remedy] Confirm whether the user name and password used in the POP3 server are correct on
CentreWare Internet Services.
027-503
[Cause] A POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
027-504
[Cause] An SMTP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
027-513
[Cause] The machine failed to transfer data using SMB of the Scan to PC service because access
to the SMB server was not permitted.
When the server is Macintosh, a folder with the same name as the specified file name
may exist on the server.
[Remedy] Consult your system administrator for settings.
027-514
[Cause] The machine failed to transfer data using SMB of the Scan to PC service because an
error has been occurred between the SMB server and the DNS server.
[Remedy] Check the following conditions:
z
The SMB server is connected to the DNS server.
z
The SMB server name is registered on the DNS server.
027-515
[Cause] The machine failed to transfer data using SMB of the Scan to PC service because an
error has been occurred.
[Remedy] Take the following measures:
z
Set the DNS server address.
z
Set the target SMB server address using IP address.
Error Code Cause and Remedy