177
Printing Basics
Loading Print Media in the Priority Sheet Inserter (PSI)
1
First print the even pages (rear sides).
For a six-page document, rear sides are printed in the order of page 6, page 4, and then page 2.
The (Data) LED blinks and the Insert Output to Tray message appears on the LCD
panel when the even pages finish printing.
2
After the even pages are printed, remove the paper stack from the center output tray.
NOTE:
• Warped or curled prints can cause paper jams. Straighten them before setting them.
3
Stack the prints and set them as they are (with the blank side facing up) into the PSI, and then
press the button.
Pages are printed in order of page 1 (rear of page 2), page 3 (rear of page 4), and then page 5
(rear of page 6).
NOTE:
• Printing on both sides of the paper is not possible if the document consists of various sizes of paper.
To Next Page
Loading...
Need help?
General
