19 Safety Notes
Others
Do not incline the product at more than 10 degree angle. Otherwise, it may fall over and cause
injuries.
The illustrations show the DocuPrint M215 fw.
To bundle wires and cables, always use the cable ties and spiral tubes that Fuji Xerox supplies.
Otherwise, it may cause some defects.
To keep this product in a good performance and condition, always use it in the following
environment:
• Temperature: 10 – 32 °C
• Humidity: 10 – 85%
When the product is left in a chilly room and the room is rapidly warmed up by heater, dew
condensation may form inside the product and cause a partial deletion on printing.
10° 10°
10° 10°
Left FrontRight BackLeft FrontRight Back
To Next Page
Loading...
Need help?
General
