Fuji Xerox DocuPrint M215 fw User Manual

343 Using the Operator Panel Menus and Keypad
•Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
NOTE:
• WSD stands for Web Services on Devices.
• IP Filter
NOTE:
• The IP Filter feature is supported for IPv4 addresses and available only for LPD or Port 9100 .
Purpose:
To block data received from certain IP addresses through the network. You can set up to five IP
addresses. To make any changes effective, turn off the printer and then turn it back on.
Values:
LPD Disable Disables the Line Printer Daemon (LPD) port.
Enable * Enables the LPD port.
Port 9100 Disable Disables the Port 9100 port.
Enable * Enables the Port 9100 port.
WSD Disable Disables the WSD port.
Enable * Enables the WSD port.
SNMP Disable Disables the Simple Network Management Protocol (SNMP)
UDP port.
Enable * Enables the SNMP UDP port.
StatusMessenger Disable Disables the StatusMessenger feature.
Enable * Enables the StatusMessenger feature.
Internet Services Disable Disables an access to CentreWare Internet Services
embedded in the printer.
Enable * Enables an access to CentreWare Internet Services
embedded in the printer.
Bonjour(mDNS) Disable Disables the Bonjour (mDNS).
Enable * Enables the Bonjour (mDNS).
No.n/Address
(n is 1 - 5.)
Sets the IP address for Filter n .
No.n/Mask
(n is 1 - 5.)
Sets the address mask for Filter n .
No.n/Mode
(n is 1 - 5.)
Reject Rejects an access from the specified IP address.
Accept Accepts an access from the specified IP address.
Off* Disables the IP Filter feature for Filter n .

Fuji Xerox DocuPrint M215 fw Specifications

General

Brand	Fuji Xerox
Model	DocuPrint M215 fw
Category	All in One Printer
Language	English