Connectivity & Network Setup
153
Tools
5
îš„ IP Mode
Allows you to select the TCP/IP operation mode.
Displays current IP mode.
z
IPv4 Mode
Select this option for IPv4.
z
IPv6 Mode
Select this option for IPv6.
z
Dual Stack
Select this option for an environment using both IPv4 and IPv6.
TCP/IP - Network Settings
Configure network settings other than common settings to use TCP/IP.
îš„ IPv4 - IP Address Resolution
Allows you to select a method for obtaining the IP address, subnet mask, and gateway
address.
z
DHCP
The address, subnet mask, and gateway address will automatically be set via DHCP.
z
BOOTP
The address, subnet mask, and gateway address will automatically be set via BOOTP.
z
RARP
The address, subnet mask, and gateway address will automatically be set via RARP.
z
DHCP/AutoIP
The address, subnet mask, and gateway address will automatically be set via DHCP/
AutoIP. If the machine fails to communicate with the DHCP server, the AutoIP function is
automatically enabled and an IP address (169.254.xxx.xxx) is assigned to the machine.
When communication between the machine and the DHCP server recovers, the machine
obtains an IP address, a subnet mask, and a gateway address by the DHCP server.
z
STATIC
Allows you to manually specify an IP address, a subnet mask, and a gateway address.
Note • To configure a subnet mask and a gateway address, an IP Address must be set first.
îš„ IPv4 - IP Address
Enter the IP address using the keyboard displayed or the numeric keypad when selecting
[STATIC] at [IPv4 - IP Address Resolution].
Note • Enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from of 0 to 255.
• Specify an IP address using numbers (0 to 9) and periods (.). If you mistyped a character on the
screen, select [Backspace] to delete the character.
îš„ IPv4 - Subnet Mask
Enter the subnet mask using the keyboard displayed or the numeric keypad when selecting
[STATIC] at [IPv4 - IP Address Resolution].
Note • Enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value from of 0 to 255.
• Specify a subnet mask using numbers (0 to 9) and periods (.). If you mistyped a character on the
screen, select [Backspace] to delete the character.
To Next Page
Loading...
Need help?
General
