5 Tools
164
Tools
5
îš„ Attribute Type of E-mail Address
Set the e-mail address attribute type. Enter a field attribute name to be used as e-mail
information from the user information registered on the LDAP server. Up to 32 characters
are allowed. For Windows, enter "mail" for an attribute name used as e-mail information.
îš„ Attribute Type of Fax Number
Set the fax number attribute type. Up to 32 characters are allowed.
îš„ Attribute Type of E-mail (Internet Fax)
Set the Internet fax address attribute type. Up to 32 characters are allowed.
îš„ Attribute Type of Custom Items 1, 2, and 3
Set the LDAP attribute type of custom items 1 to 3. In addition to [Attribute Type of Name]
and [Attribute Type of E-mail Address], you can assign user attributes registered on the
LDAP server for a search. Up to 32 characters are allowed.
îš„ Attribute Name of Custom Items 1, 2, and 3
Set the attribute names assigned to custom items 1 to 3. Up to 16 single-byte characters are
allowed.
îš„ Attribute Type of Certificate
Set the certificate attribute type. Select and enter the field name to use as a certificate from
among the user information registered on the LDAP server. Up to 32 single-byte characters
are allowed.
For Windows, enter "userCertificate;binary" for an attribute name used as certificate
information. The information is used as an S/MIME certificate when you specify an address
using the directory service to encrypt e-mail transmission by S/MIME.
Note • To encrypt communications using this feature, a trusted root certificate authority and all
intermediate certificate authorities that are registered in the path of a certificate to use must be
registered.
îš„ Maximum Number of Search Results
Set a maximum number of address to display from search results from 5 to 100. If the
search results exceed the maximum, the search stops at the maximum number set. The
default value is 50.
îš„ Search Time-Out
Select whether or not to set a search time-out. Set the value from 5 to 120 seconds in 1
second increments.
SMB Server Settings
Set the following items to use SMB server as a remote authentication server.
îš„ SMB Server Setup
Select the server specification method from [By Domain Name] and [By Domain & Server
Names/IP Address].
According to the option you selected here, set [Domain Name] and [Server Name/IP
Address] for SMB servers 1 to 5 respectively. The setting for SMB server 1 is used as the
default setting for authentication.
îš„ Domain Name
Enter the domain name of the server. Up to 64 characters are allowed.
This setting is mandatory regardless of the SMB server specification method selected for
[SMB Server Setup].
To Next Page
Loading...
Need help?
General
