ESC/P-K Emulation
513
Appendix
15
Extended Settings
Setting Item Item Number Value
Paper position 20 Sets the paper position.
[0] (Default) : Without cut sheet feeder (left)
[1] : With cut sheet feeder (center)
Note • When [Without cut sheet feeder (left)] is specified and FF (line feed
command) is received, the machine skips the number of lines specified in
VFU. When [With cut sheet feeder (center)] is specified, the machine
inserts a page break.
• When a continuous form paper is selected for [Original Size], [Paper
Position] cannot be set.
Output quantity 8 Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
Important • When the output quantity is specified by a client, that number of copies is
printed. After printing, the number set on the control panel is overwritten
with the number newly specified. However, the number of copies specified
from the LPD port will not overwrite the number set on the control panel.
Reduce/Enlarge 54
(Reduce/
Enlarge mode)
Sets the print magnification.
[0] (Default) : Preset %
[1] : Variable %
[2] : Fit to Cut Sheet
[Preset %] is a magnification automatically calculated based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
document to fit in the printable area of the output paper. Therefore, when
the size of the document and the output paper are the same, the ratio will be
100%. Also, if [2 Up] is selected, the document will be reduced to the size at
which two pages fit onto one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/Enlarge]. A
reference point for scaling (reducing/enlarging) is the upper left corner of the
printable area. This reference point applies to all text, images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area onto the printable area of
the output paper. It is a magnification automatically calculated based on
[Original Size] and [Paper Size], and reduces/enlarges the entire document
(including the area outside of the printable area) to fit onto the printable
area of the output paper.
17
(Variable %/
vertical
magnification)
Sets the magnification for the vertical or horizontal direction.
[45 to 210] (Default:100): 45-210%
Note • When a continuous form paper is selected for [Original Size], print result is
identical for [Preset %] and [Fit to Cut Sheet].
18
(Variable %/
horizontal
magnification)
2 Up mode 21 Sets whether to print with the 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the other.
[0] (Default) : Off
[1] : Forward
[2] : Reverse
Important • When [Landscape] is selected for [Original Size], print result is identical for
[Forward] and [Reverse].
To Next Page
Loading...
Need help?
General
