FujiFilm FinePix F11 - Page 25

49
Advanced Features
3
48
◆
Area shot and quality setting
◆
Normal shooting provides an
aspect ratio of 4:3 and “
„ ”
shooting provides an aspect ratio
of 3:2 (same aspect ratio as 35 mm
film and post card).
Area shot with “
„
”
NNN
101010
101010
Area shot excluding “
„
”
„
(3024 × 2016)
Printing at up to 4R (10.2 × 15.2 cm) / A6 size
2
(1600 × 1200)
To use for e-mail or web site
`
(640 × 480)
Printing at up to 6R (15.2 × 20.3 cm) / A5 size
3
(2048 × 1536)
Quality mode
5
N (2848 × 2136)
Printing at up to 10R (25.4 × 30.5 cm) / A4 size
For better quality, select “
5 F”
5
F (2848 × 2136)
Sample uses
Quality settings in Photography mode
Choose from 6 settings. Using the table below as a guide, select the setting that best suits your
aims.
NN
F
N
QUALITY
QU A LI TY
AUTOAU TO
STDST D
PHOTO MODEPH O TO M OD EPH O TO M OD EPHOTO MODE
:
:
:
1
1Set the Mode switch to Photography mode.
2Press the “p” button to display the menu on the
LCD monitor.
1Press “a” or “b” to select “
˘” QUALITY.
2Press “c”.
The quality setting is retained even when the
camera is turned off or the mode setting is changed.
2
01 02
01 02
PHOTO MODEPH O TO M OD EPH O TO M OD EPHOTO MODE
F
N
N
10 FRAMES F RA M ES
AUTOAU TO
STDST D
2848x2136:
:
:
:
1Press “a” or “b” to change the setting.
2Press the “MENU/OK” button to confirm the
setting.
●
! The number in the top right corner of LCD monitor shows the
number of available frames.
●
! When changing the quality setting, the number of available
frames also changes (➡P.24).
3
01 02
˘ QUALITY MODE
(
NUMBER OF RECORDED PIXELS
)
p PHOTO MODE PHOTOGRAPHY