EasyManua.ls Logo

FujiFilm IS Pro - Page 67

FujiFilm IS Pro
244 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
67
Advanced Features — Photography
Z Buffer Size
The number of shots available before the memory
buffer is full is displayed in the viewfinder and control
panel while the shutter button is pressed. The
continuous shooting can record up to 100 frames.
If 0 is displayed, the memory buffer is full and shooting
will slow.
The number of shots available before the memory
buffer is full, which is displayed in the viewfinder and
control panel, varies depending on the capacity of the
memory card or shooting conditions.
MEMO
In continuous mode, the orientation recorded for the
first shot applies to all photographs in the same burst,
even if camera orientation is changed during shooting.
While photographs are being recorded to the memory
card, the access lamp next to the memory card slot will
light. Depending on the memory card type, image size
( RECORDING PIXELS) or image quality
( QUALITY), recording time may vary from a few
seconds to a few minutes. Do not remove the memory
card or disconnect the power source until the access
lamp has gone out. If the camera is switched off while
data remains in the buffer, the power will not turn off
until all images in the buffer have been recorded. If the
battery is exhausted while images remain in the buffer,
the shutter release will be disabled and the images
transferred to the memory card.

Table of Contents

Related product manuals