Downloaded from Projector.com
XP60 Projector
2 - English A26361-K865-Z100-1-5E19
Notational conventions
The meanings of the symbols and fonts used in this manual are as follows:
!
Pay particular attention to text marked with this symbol. Failure to observe this warning
endangers your life, destroys the device, or may lead to loss of data.
i
Supplementary information, remarks, and tips follow this symbol.
Ê Text which follows this symbol describes activities that must be performed in the order shown.
"Quotation marks" indicate names of chapters or terms.
Important notes
!
Here you will find essential safety information regarding your projector.
Safety
This device complies with the relevant safety regulations for data processing equipment, including
electronic office machines for use in an office environment. If you have any questions, contact your
sales outlet or our customer service centre.
• Before you operate the project for the first time, read this Operating Manual carefully.
• Never open the unit. The projector contains no user-replaceable parts. Any repairs should only
be performed by a qualified repair shop.
• If the device is brought into the installation site from a cold environment, condensation can
form. Before operating the device, wait until it is absolutely dry and has reached approximately
the same temperature as the installation site.
• During installation and before operating the device, observe the instructions on environmental
conditions in the chapter "Technical data".
• To keep the projector from overheating, never cover it while it is running. Keep all air openings
clear. Do not place the projector on heat-sensitive material.
• Do not operate the projector near any heat sources.
• The projector automatically sets itself to the correct voltage within the range from 100 V to
240 V. Ensure that the local mains voltage lies within these limits.
• Ensure that the power socket on the projector or the grounded mains outlet is freely accessible.
• The ON/OFF switch does not disconnect the device from the mains voltage. To completely
disconnect the mains voltage, remove the power plug from the socket.
• If you do not use the projector for a longer period of time, shut off the power source completely
(for example, by switching off a power bar) or disconnect the power cable from the projector.
• Use only the included power cable or a cable that is approved for your country.
• Lay all cables so that nobody can stand on them or trip over them. When attaching the device,
observe the relevant notes in the chapter "Preparing remove control".
To Next Page
Loading...
Need help?
General