Downloaded from Projector.com
Projector XP60
A26361-K865-Z100-1-5E19 English - 9
!
The computer power plug must be pulled out!
Connecting the data cable
1
2
3
1 = Data connector for connection to computer
2 = Data connector for connection to projector
3 = USB connector
Ê Connect the connector (1) of the data cable to the active monitor port on the computer and
secure the plug-in connection by tightening the safety screws.
i
If your computer has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is usually active.
Ê Connect the plug (1) of the data cable to the M1-DA connector (4) at the back of the projector.
Connecting the USB cable
The projector has a computer interface with integrated USB functions. If your computer has a USB
port and a driver for a USB mouse is loaded, you can control the computer with the projector’s
remote control as with a mouse. Proceed as follows:
Ê Insert the USB connector of the data cable (3) into the USB port on the computer (consult your
computer’s manual).
Connecting projector to video sources
You can connect a camcorder or similar video device with the included accessory cable to the
"Video" and "Audio in" sockets. With the SCART cable, you can connect other video sources, for
example a video recorder.
You can connect corresponding video signal sources to the "S-Video" connection. The necessary S-
Video cable is not included.
You can connect a stereo output signal from your computer or from your audio/video source to the
"Audio in" port with the cables provided in the accessories pack. Playback then takes place via the
integrated loudspeaker. The volume can be adjusted with the "Volume" buttons in the control panel
of the projector or in the control panel of the remote control.
Check the respective device manuals for additional information.
To Next Page
Loading...
Need help?
General