EasyManuals Logo

Fujitsu Siemens Computers XP60 User Manual

Fujitsu Siemens Computers XP60
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Downloaded from Projector.com
Projector XP60
A26361-K865-Z100-1-5E19 English - 3
No data transmission cable should be connected or disconnected during a thunderstorm.
Make sure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get inside the
device (danger of electric shock, short circuit).
If you notice an unusual smell, see smoke, and in emergencies (e.g. damaged casing,
components or cables, penetration of liquids or foreign matter), switch the unit off, disconnect
the power plug and contact your sales outlet or our customer service center.
Only qualified technicians should repair the device. Unauthorised opening and incorrect repair
may greatly endanger the user (electric shock, fire risk).
Do not look into the lens while the projector is running.
Never look into the remote control's laser pointer beam.
Never point the laser pointer at living beings, especially not at their eyes.
To avoid injuries, always place the projector on a solid surface and use only the approved
cover mount.
You may set only those resolutions and refresh rates specified in the "Technical data" chapter.
Allow the projector to cool down before you pack it up or transport it.
Keep this operating manual together with your device. If you pass on the device to third parties,
you should include this manual.
Cleaning notes
Always pull out the power plug before you clean the projector.
Do not clean any interior parts yourself, leave this job to a service technician.
Do not use any cleaning agents that contain abrasives or may corrode colours.
Ensure that no liquid will run into the system.
Regularly clean the projector's air vents to maintain sufficient cooling air flow.
The surface of the lens is sensitive to pressure and scratches. Clean it only using a soft,
slightly moistened cloth.
Wipe the projector casing with a dry cloth. If the monitor is particularly dirty, use a cloth which has
been moistened in mild domestic detergent and then carefully wrung out.
Transport notes
Allow the projector to cool down before you pack it up or transport it.
Transport the projector with care and only in its original packaging or another corresponding
packaging fit to protect it against knocks and jolts.
Above all, never drop the projector.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu Siemens Computers XP60 and is the answer not in the manual?

Fujitsu Siemens Computers XP60 Specifications

General IconGeneral
BrandFujitsu Siemens Computers
ModelXP60
CategoryProjector
LanguageEnglish