EasyManuals Logo

Fujitsu A512 User Manual

Fujitsu A512
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
Troubleshooting and tips
Error messages on the screen
Errormess agesont he screenErrormessage:
This section describes the e rro r messages generated by the BIOS Setup. Error messages displayed
by the operating system or programme s are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact th e place of purchase or o ur customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occurs repeatedly, the
buffer battery in the notebook is at.
Contact your sales outlet
or our cust omer
service centre.
System CMOS checksum bad - default conguration
used
The system conguration information is
incorrect.
Switch the notebook of
f.
Switch the notebook on.
Press the function k
ey
F2
to access the
BIOS Setup.
In the BIOS Setup, select the Exit menu.
Select the entry Lo
ad Setup Defaults.
Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extende d m emory an error has
resulted at the address xxxx.
Check whether the additional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive a re incorrect.
Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboard contro ller error
Switch the notebook off with the ON/OFF
switch.
Wait 3 - 5 s econds and switch on the
notebook again.
Keyboard error
If you are using an external k eybo ard:
Check the connection and re boot the
notebook.
nn Stuck key
Make sure that no key is pressed.
Operating system not fo und
Check
in the BIO S Setup whether your hard
disk h
as been set correctly.
Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the se lf-test before starting the operating
system.
Press the
F1
function key to start the
operating system.
Press the function key
F2
to access the
BIOS Setup.
64 Fujitsu

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu A512 and is the answer not in the manual?

Fujitsu A512 Specifications

General IconGeneral
BrandFujitsu
ModelA512
CategoryLaptop
LanguageEnglish

Related product manuals