A26391-K147-Z120-1-7619 47
Settings in BIOS Setup
In BIOS Setup you can set the system functions and the hardware configuration of the notebook. The
settings can only be changed via the keyboard.
When it is delivered, the notebook is set to factory default settings. You can change these settings
in BIOS Setup. Any changes you make take effect as soon as you save and quit the BIOS Setup.
The BIOS Setup programme contains the following menus:
Main: for system settings as time, date, hard disk and monitor selection
Advanced: for system settings such as ports and keyboard
Security: for password settings and safety functions
Power: for setting the energy saving functions
Boot: for configuring the boot sequence
Exit: to exit the BIOS Setup
Start BIOS Setup
► Restart the notebook (switching ON/OFF or warm boot).
The following or a similar display appears on the screen during booting:
<F2> Setup menu <F6> Battery learning <F12> Boot menu
► When this message appears, press the key F2 .
i
If a password has been assigned:
► Enter the password and press the Enter key.
If you have forgotten the password, contact your system administrator or contact our
hotline/help desk.
To Next Page
Loading...
Need help?
General
