Fujitsu ASTG30KMTC - Function Settings (Outdoor Unit: AOTG34 KMTC Only); Outdoor Unit Local Setting Switch Buttons

2-2. Local setting procedure
NOTE: Before performing the function setting, be sure to stop the operation of the air conditioner.
¢
Low noise mode
SW1
S
W2
SW3 SW4 SW5
(1) (2) (3) (4) (5)
LED lamps
Switch buttons
1. Press the MODE switch button (SW1) for 3 seconds or more to switch to “Local setting mode”.
2.
After confirming the LED lamp of POWER/MODE blinks 9 times, press the ENTER switch but-
ton (SW3).
POWER
MODE
ERROR
(L1) (L2) (L3) (L4) (L5) (L6)
PUMP
DOWN
LOW NOISE PEAK CUT
Blinks
(9 times
)
Sign “ ”: Lights off
3. Press the SELECT switch button (SW2), and adjust the LED lamp as shown below. Then the
LED lamp indicates the current setting.
(L2)
(L
3)
LOW NOISE
Blink
LOW NOISE
MODE
4. Press the ENTER switch button (SW3).
(L2) (L3)
LOW NOISE
LOW NOISE
MOD E
Sign “
”: Lights on
5. Press the SELECT switch button (SW2), and adjust the LED lamps as shown below.
PEAK CUT
MODE 1: Low
MODE 2: Lower
Blink
Blink
(L4) (L5) (L6)
2-2. Local setting procedure - (05-12) - 2. Function settings (For outdoor unit: AOTG34KMTC only)
FIELD WORKING FIELD WORKING