Troubleshooting
Troubleshooting
Should an error occur, first check the following points. If the distortion is s till not eliminated,
the monitor should, if possible, be checked on another compute r.
If you cannot solve the problem, please contact our Service Desk.
Having this problem? Check the follo wing points:
No screen display
Power indicator does not light up
► Ch eck whether the power cable on the
monitor is connected correctly.
► Ch eck wheth er the comput
er is switched on.
No screen display
Power indicator is lit
► Ch eck wheth er the computer is switched on.
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Press any key on the computer keyboard.
The compute r may be in p ower saving
mode.
► Alter the brightness and/or contrast until you
get a picture.
Message: No Signal
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Ch eck wheth er the computer is switched on.
Message:
Frequency out of range:
##kHz/##Hz
Please change the display mode to
1920 x 1200 with 60 Hz
The input sign
al (horizontal frequency and
refresh rate
) at the displayed input does not
correspond t
o the technical data f or the monitor.
► Adjust the v
ideo frequency range using
the compute
r software ( refer to the
documentat
ion for the computer or g raphics
card).
► Select a valid screen resolution using
the computer software (refer to the
documentation for the computer or graphics
card).
Picture position not correct
The monitor recognises an undefined mode (see
chapter "
Technical specification", Page 35).
► Press the
AUTO
button to conduct the
auto-adjustment of the screen.
Picture is shaking
► Check whether the data cable for the
monitor is correctly attached to the monitor
port on the computer.
► Press the
AUTO
button to conduct the
auto-adjustment of the screen.
Picture is wro ngly adjusted
► Ru n
the Factory Recall function in the OSD
me
nu.
The Auto Processing message appears.
32 Fujitsu
To Next Page
Loading...
