Getting started
Removing monitor base
Before you can use a swivel arm or a similar accessory, you must remove the monitor base.
The display surface is su sceptible to scratching!
1
2
► Switch off the monitor and pull the power
plug out of the po w er so cket.
► Lay the monitor on its face on a soft surface.
► Disconnect all cables.
► Release the base stand by moving the slider
in the direction of the arrow (1) and hold it
while lifting the c omplete ba se sta nd up (2).
Yo u can now mount a swivel arm or a
similar accessory in accordance with VESA
FPMPMI using a hole spacing of 100 mm.
For instructions on how to mount the swivel arm or a similar accessory, please
see the documentation for the swivel arm or similar accessory.
Connecting
the device
Please observe the safety information in "Important notes", Page 7.
CE conformance and optimum picture quality are guaran teed only if
you use the data cables supplied.
► Sw itch off the monitor and the computer.
► D isconnect the power plug from the computer.
16 Fujitsu
To Next Page
Loading...
Need help?
General
