Application Unit PY: AU47 Application Unit
10 U41861-J-Z126-4-76
2.1.2 Application Unit AU47
AU47s require 4 height units in the rack. AU47s are set up on the same system unit as the
PRIMERGY servers RX4770 M<x> and use the same system board. Differences in the
basic units exist to permit integration of the Application Units into the SE server and to
enhance the SE server’s redundancy features.
In the event of questions, e.g. regarding application compatibility, the information for the
PRIMERGY servers RX4770 M<x> also applies for the Application Units of the SE server.
Security functions in the BIOS setup and on the system board protect the data against
manipulation. Information on the security functions is provided in the manual "D<nnnn>
BIOS Setup Utility for FUJITSU Server PRIMERGY RX4770 M<x>" on the Manual Server
(http://manuals.ts.fujitsu.com):
Ê Go to x86 Servers→ PRIMERGY Servers, select PRIMERGY RX Servers, and then the
model PRIMERGY RX4770 M<x> under RX 4770 Series.
i Over the course of 2017, the current model of the PRIMERGY server RX4770 M3
will become the hardware basis for AU47. When an innovation of the PRIMERGY
server will take place in the future, the newer variants will also be released as the
hardware basis for AU47.
Features
Application Units contain two or four Intel XEON processors, have a storage capacity of up
to 6 TB and offer ten PCI express slots.
Detailed information on the various hardware components and interfaces of the Application
Units is provided in the data sheet "FUJITSU Server BS2000 SE Series". See the product
site for the relevant server at http://www.fujitsu.com/uk:
Ê Go to Products → Servers → BS2000 → FUJITSU Server BS2000 and select SE700,
SE500 or SE300.
To Next Page
Loading...
