Fujitsu BS2000 - Working with the Tape Library; Modes of the Tape Library

ETERNUS LT40 S2 tape library Periphery
50 U41861-J-Z126-4-76
Figure 22: ETERNUS LT40 S2 front panel
1 Left-hand or right -hand magazine. Left-hand magazine with mailslots.
2Air vents
3 Power button. Pressing the button will power up or power down the library, see page 53 and
page 56.
4 READY LED (green).
Illuminated when power is on.
Blinking when there is tape or robotics activity.
5 CLEAN LED (yellow).
Illuminated when the tape drive has determined that a cleaning cartridge should be used.
6 the OCP's LCD screen, consisting of 128 x 64 characters.
Displays actions and status information, menu items or error messages.
7 ATTENTION LED (yellow).
Illuminated if the library has detected a condition that requires attention by Customer Support.
Please notify customer support.
8 ERROR LED (yellow).
Illuminated if an unrecoverable tape drive or library error occurs. A corresponding error
message displays on the LCD screen.
Please notify customer support.
9 Control key buttons ▲ (UP) and ▼ (DOWN).
These buttons are used to navigate through the OCP menu items.
10 Control key buttons CANCEL and ENTER.
The cancel button is used to cancel a user action and return to the last OCP menu item.
The enter button is used to go to a sub menu or execute an action.
1
6
5789 2
2
3
4
1
10