Application Unit Application Unit PY: AU25
U41861-J-Z126-4-76 9
Dokuschablonen 19x24 Version 7.4de für FrameMaker V7.x vom 09.02.2010 © cognitas GmbH 2001-2010
5. March 2018 Stand 17:30.42 Pfad: P:\FTS-BS\Server\SE-Server\SE-Doku\1303919_BA_Additional_update_3\prod_e\ba_addon.k03
2.1 Application Unit PY (SE AU PY)
The Application Unit PY (SE AU PY) are based on the different models of the FUJITSU Ser-
ver PRIMERGY series.
2.1.1 Application Unit AU25
AU25s require 2 height units in the rack. AU25s are set up on the same system unit as the
PRIMERGY servers RX2530 M<x> and use the same system board. Differences in the
basic units exist to permit integration of the Application Units into the SE server and to
enhance the SE server’s redundancy features.
In the event of questions, e.g. regarding application compatibility, the information for the
PRIMERGY servers RX2530 M<x> also applies for the Application Units of the SE server.
Security functions in the BIOS setup and on the system board protect the data against
manipulation. Information on the security functions is provided in the manual "BIOS Setup
Utility for FUJITSU Server PRIMERGY RX2530 M<x>" on the Manual Server
(http://manuals.ts.fujitsu.com):
Ê Go to x86 Servers→ PRIMERGY Servers, select PRIMERGY RX Servers and then RX 2530
Series.
i When the Service Pack 1 of the SE V6.2A is released, the AU25 M4 is also released
after the AU25 M1.
Features
AU25s contain two or two Intel XEON processors, have a storage capacity of up to 1.5 TB
and offer four PCI express slots.
Detailed information on the various hardware components and interfaces of the Application
Units is provided in the data sheet "FUJITSU Server BS2000 SE Series". See the product
site for the relevant server at http://www.fujitsu.com/uk:
Ê Go to Products → Servers → BS2000 → FUJITSU Server BS2000 and select SE700,
SE500 or SE300.
To Next Page
Loading...
