Working with the notebook
Wireless LAN/ Bluetooth (device-dependent)
/ UMTS (device-dependent)
The installation of a radio components not approve d by Fujitsu Technology
Solutions will invalidate the certifications issued for this device.
Switching the wireless components on a nd off
Before switching on your device for the first time, the on/off switch for
radio com ponents must be in the "ON" positio n.
► Slide the ON/OFF switch into the "ON"
position to act ivate the radio components.
Wireless LANWireless LANBluetoothBluetooth
or
► Slide the ON/OFF sw
itch to the
"OFF" position to
deactivate the
radio componen ts
.
If you switch off the radio components, the wireless LAN transmission unit (antenna)
and, if p resent, the Bluetooth and U MTS module will also be switched off.
You can enable and disable the installed radio components individually
using the WirelessSelector programme
You can also deactivate the wireless components individually in the BIOS Setup.
For this to occur, you must either not have assigned a supervisor passw ord or if a
supervisor password has been assigned, you must know this password.
Pay attention to the additional safety notes for devices with ra dio components
provided in the "Safety/Regulations" manual.
Details on using Wireless LAN can be found in the online help system
included in the Wireless LAN software.
You can find more information on how to use Bluetooth on the CD you
received with your Bluetooth software.
You can obtain more information on UMT S from your service pro vider.
Fujitsu Technology Solutions 47
To Next Page
Loading...
