Chapter 5 Host Interface Management
5.2 Modify Port Parameters
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
73
2 Set the parameters for all of the selected ports.
The settings of port parameters vary depending on the port mode ("When the port mode is "CA"" (page
73), "When the port mode is "RA" or "CA/RA"" (page 74), or "When the port mode is "Initiator"" (page
74)).
■ When the port mode is "CA"
The main setting items are as follows.
● Port Settings
• Port
• Connection
• Set Loop ID
• Loop ID
• Transfer Rate
• Multiple selections can be made from FC ports that have the same "Type" and "Port Mode".
• Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.
To Next Page
Loading...
