Fujitsu ETERNUS DX100 S3 - Page 77

Chapter 5 Host Interface Management
5.2 Modify Port Parameters
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
77
2 Set the parameters for all of the selected ports.
The settings of port parameters vary depending on the port mode ("When the port mode is "CA"" (page
77), "When the port mode is "RA"" (page 78), or "When the port mode is "CA/RA"" (page 80)).
■ When the port mode is "CA"
When the type is "1G iSCSI" or "10G iSCSI" and the port mode is "CA", specify the following items:
The main setting items are as follows.
● Select Port
• Port
● General Information
• iSCSI Settings
- iSCSI Name
- Alias Name
• TCP/IP Settings
- IP Version
- IP Address
- Subnet Mask
- Gateway
- IPv6 Link Local Address
- IPv6 Connect IP Address
- IPv6 Gateway
- TCP Port No.
- TCP Window Scale
- VLAN ID
- Jumbo Frame