Fujitsu ETERNUS DX100 S3 - Page 17

Figure 1.2 Example of Basic System Configuration
The Express's manager and Web Console can be operated on different servers. In this environment, Web Console accesses to the
Express's manager over the network (HTTPS connection).
System Configuration Using Advanced Copy Function
In Express, the Management Server sends a command to ETERNUS Disk storage system to perform an Advanced Copy function. There
are two available methods for sending the copy command:
- Sending a command to ETERNUS Disk storage system to perform an Advanced Copy function from the server over the SAN (hereafter
referred to as "Copy command via SAN")
- Sending a command to ETERNUS Disk storage system to perform an Advanced Copy function from the server over the LAN (hereafter
referred to as "Copy command via LAN")
The following table describes the requirements for the two copy methods, via SAN or via LAN, for each type of system:
Device Name
Copy Command via SAN Copy Command via LAN
Operation Firmware Version Operation Firmware Version
ETERNUS DX60
ETERNUS DX80
A All versions N/A -
ETERNUS DX90 A All versions A (*1) V10L61 or later
ETERNUS DX60 S2 A All versions N/A -
ETERNUS DX80 S2
ETERNUS DX90 S2
A All versions A All versions
ETERNUS DX60 S3
ETERNUS DX100 S3
ETERNUS DX200 S3
A All versions A All versions
- 3 -