Fujitsu ETERNUS DX60 S2 - Connection Setup for the ETERNUS DX Disk Storage System and Power Synchronized Units

Chapter 5 Setup
5.3 Connection Setup for the ETERNUS DX Disk Storage System and Power Synchronized Units
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User’s Guide -Installation-
125
Copyright 2014 FUJITSU LIMITED P3AM-5502-05ENZ0
3 Set each item under "Customer Information" and "Communication Environment
Information" in the [Setup Remote Support] screen.
4 Click the [Set] button.
A confirmation screen appears.
5 Click the [OK] button. The remote support settings are applied.
The specified information is sent to the remote support center and the connection of the
ETERNUS DX Disk storage system and the remote support center is checked. The result
of connection check is sent to "Administrator E-Mail Address".
End of procedure
5.3 Connection Setup for the ETERNUS DX Disk Storage
System and Power Synchronized Units
Refer to "User's Guide -Power Synchronized Unit-" that is provided with the power synchronized
unit for the required settings to use power control by connecting power synchronized units to an
ETERNUS DX Disk storage system.