Fujitsu ETERNUS DX60 S2 - When 2 U Power Distribution Unit Is Installed (for Regions Other than EMEA&I)

Chapter 4 Connecting Cables
4.5 Power Cord Connection
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User’s Guide -Installation-
76
Copyright 2014 FUJITSU LIMITED P3AM-5502-05ENZ0
6 Turn the main line switch of the power supply unit to the ON position (marked
"|").
AC power is supplied to the enclosure, and the STATUS LED of the power supply units
emit a green light.
End of procedure
4.5.3 When 2U Power Distribution Unit is Installed (For Regions other than
EMEA&I)
The following section explains how to connect a power cord when a Power distribution unit for
DX Disk storage system (2U, Max 6 enclosures connection) is installed.
IMPORTANT
Make sure all of the main line switches are in the ON position.
Main Line Switch
This section explains the connection procedure for power distribution units
(2U, Max 6 enclosures connection). This procedure can also be applied for
Power distribution unit for ETERNUS DX Disk storage system (2U, Max 8
enclosures connection).
IMPORTANT
To help with power cord management and prevent incorrect connections,
attach labels to the power cords and make a note of connection origins and
destinations.