Fujitsu ETERNUS DX60 S2 - Export Configuration

Chapter 1 Preparation
1.1 Connection Preparation
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User’s Guide -Installation-
23
Copyright 2014 FUJITSU LIMITED P3AM-5502-05ENZ0
1.1.2.3 Notes on LAN Connection
■ Network communication protocols
The usable LAN ports and functions are different depending on the usage and protocol.
The following table shows how the LAN ports may be used (by usage and protocol).
Table 1.2 LAN port availability
Yes: Available / No: Not available
*1: Only the following functions are available:
- Checking the ETERNUS DX Disk storage system status
- Switching the Master CM
*2: May use either the MNT port or RMT port.
*3: Modifiable
*4: REMCS is available for regions other than EMEA&I.
For details on the port numbers for the following Storage Foundation Software ETERNUS SF,
refer to the manual of each Storage Foundation Software ETERNUS SF.
• ETERNUS SF Storage Cruiser
• ETERNUS SF AdvancedCopy Manager
• ETERNUS SF Express
Usage Protocol
tcp /
udp
Port
number
Direction
Master CM Slave CM
Remarks
MNT RMT MNT RMT
ETERNUS Web
GUI
http /
https
tcp 80 / 443 from
Yes No *1 *1
Accessed from
a Web browser
ETERNUS CLI telnet /
ssh
tcp 23 / 22 from
Yes Yes *1 *1
–
ftp
(client)
tcp 21 to
Yes Yes *1 *1
–
SNMP agent snmp udp 161 from Yes Yes Yes Yes –
trap snmp
trap
udp 162 (v1)
Must be set
(v2c/v3)
to Yes
(*2)
Yes
(*2)
No No –
SMI-S http /
https
tcp 5988 / 5989 from
Yes No No N o
Used for SMI-S
client
communication
E-mail smtp
(client)
tcp 25 (*3) to Yes
(*2)
Yes
(*2)
No No
Used for failure
notification, etc.
NTP NTP udp 123 to Yes
(*2)
Yes
(*2)
No No
–
REMCS (*4)
(remote
support)
smtp tcp Must be set to Yes
(*2)
Yes
(*2)
No No
Used for failure
notification, etc.
http
(client)
tcp Must be set to
Yes
(*2)
Yes
(*2)
No No
Used for
firmware
download, etc.