Chapter 1 Preparation
1.2 Setup Preparation
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User’s Guide -Installation-
25
Copyright 2014 FUJITSU LIMITED P3AM-5502-05ENZ0
❏ Attaching the Network Settings label
Attach the completed Network Settings label on the label plate in the label holder on the rear
upper side of the controller enclosure.
Figure 1.9 Attaching Network Settings label
■ Preparation and settings for the PC terminal
The initial settings are performed by using a Web browser on the PC terminal.
Prepare and set up the PC terminal before the initial settings.
❏ Preparing the PC terminal
Prepare the PC terminal that contains the following environment:
- Web browser
Usable Web browsers are as follows. Using Web browsers other than the following is
possible, but proper operation is not guaranteed.
• Microsoft Internet Explorer 6.0, 7.0, 8.0, 9.0, 10.0 (desktop version)
• Mozilla Firefox 3.0.x, 3.5.x, 3.6.x, ESR 10.0.x, ESR 17.0.x
Label holder
Network Settings label
Network Setting
: . . .
: . . .
: . . .
: . . .
IP address of MNT port
IP address of FST
Subnet Mask
IP address of RMT port
Pull out the plate while holding the tag.
Ta g
Plate
The following items are supported in firmware version V20L15 or
later:
• Internet Explorer 9.0, 10.0 (desktop version)
• Firefox ESR 10.0.x, ESR 17.0.x
To Next Page
Loading...
