EasyManua.ls Logo

Fujitsu Eternus DX90 - Table 2.5 Host Response Settings

Fujitsu Eternus DX90
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 2.5 Host response settings
OS Conditions Parameter Setting value
Solaris (*1) When MPxIO is used and the Multi-
path Diagnostic Program or En-
hanced Support Facility 5.1 or later
is installed
Reservation Conflict Response for
Test Unit Ready
Conflict
Sense Data Conversion MPxIO Recommended
When MPxIO is used for purposes
other than described above
Reservation Conflict Response for
Test Unit Ready
Conflict
Sense Data Conversion Linux Recommended
(When not using
GRMPD)
When the ETERNUS Multipath Driver
or VxVM is used
All parameters Default value
HP-UX Common (required setting) Host Specific Mode HP-UX Mode
When Integrity VM is used Sense Data Conversion Linux Recommended
(When not using
GRMPD)
AIX (*2)
VIOS
Common (required setting) Host Specific Mode AIX Mode
When one of the following condi-
tions applies
ETERNUS Multipath Driver 2.0 is
used
When FJspio is used and PowerHA
or HACMP is used for a single path
configuration
Reservation Conflict Response for
Test Unit Ready
Conflict
Windows
®
(*3)
When one of the following condi-
tions applies
The OS standard multipath driver
(msdsm) is used
VxVM is used
Sense Data Conversion Windows Recommen-
ded (When not using
GR/ETERNUS MPD or
Device Driver)
When one of the following condi-
tions applies
SAN Boot is configured with the
PRIMEQUEST 1000 series
SAN Boot is configured with the
PRIMEQUEST 500/400 series
Sense Data Conversion Linux Recommended
(When not using
GRMPD)
When the ETERNUS Multipath Driver
is used
All parameters Default value
When MSCS is used on Windows
Server
®
2003
Reservation Conflict Response for
Test Unit Ready
Conflict
Linux When one of the following condi-
tions applies
The OS standard multipath driver
(device mapper) is used
VxVM is used
SAN Boot is configured with the
PRIMEQUEST 1000 series
SAN Boot is configured with the
PRIMEQUEST 500/400 series
Sense Data Conversion Linux Recommended
(When not using
GRMPD)
Conditions that are not listed above All parameters Default value
Chapter 2 Setting Up the ETERNUS DX
2.1 Common Settings
10
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
P3AM-3182-15ENZ0

Other manuals for Fujitsu Eternus DX90

Related product manuals