Table 2.3 FC port parameter settings (Fabric connection)
Parameter Setting value
Connection Fabric
Frame Size 2048 bytes (Default value)
Transfer Rate See the table below (*1)
Host Affinity Enable
Reset Scope I_T_L (Default value)
Release Reservation if Chip is Reset Disable (Default value)
*1: Set the appropriate value from the following table. Do not use [Auto].
Table 2.4 Transfer rate setting values
Fibre Channel switch or CEE/FCoE
switch maximum speed
Transfer rate setting value
8Gbit/s CA 4Gbit/s CA
8Gbit/s 8Gbit/s 4Gbit/s
4Gbit/s 4Gbit/s 4Gbit/s
2Gbit/s 2Gbit/s 2Gbit/s
1Gbit/s — 1Gbit/s
When setting a Fabric connection, complete the preparatory work and set up the Fibre Channel switch or
the CEE/FCoE switch beforehand. For setting details, refer to "FUJITSU Storage ETERNUS DX Configuration
Guide -Server Connection- (Fibre Channel) Fibre Channel Switch Settings", "Converged Enhanced Ethernet
Administrator's Guide", or "Fabric OS Administrator's Guide".
2.1.2 Sense Data Conversion (Setting the Host Responses)
The ETERNUS DX sense data conversion must be set to match the way in which the server will process the
ETERNUS DX request responses.
Set the parameters according to the conditions that are described in Table 2.5.
Retain the default values for all of the parameters that are not described below. If multiple conditions apply,
set the parameters so that all of these conditions are met.
When setting the access path using the ETERNUS SF Storage Cruiser, the host responses for FC host will be
set to default values. Set the host responses after setting the access path using the ETERNUS SF Storage
Cruiser.
Chapter 2
Setting Up the ETERNUS DX
2.1 Common Settings
9
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
P3AM-3182-15ENZ0
To Next Page
Loading...
