Fujitsu ETERNUS LT60 S2 - Linux

Chapter 1 Overview
1.2 References for Setup
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
22
1.2.2 Linux
1.2.2.1 SAS Connection for Linux [SAS Model]
The following procedure explains how to connect the LT20 S2/LT40 S2/LT60 S2 to a Linux server with a SAS
connection.
Workflow
Setting Backup Software
Apply patches, set the robot driver, and set the backup software.
• Backup software used
- NetBackup
• "4.1 NetBackup" (page 47)
- NetWorker
• "4.2 NetWorker" (page 51)
- IBM Spectrum Protect (IBM Tivoli Storage Manager)
• "4.3 IBM Spectrum Protect" (page 53)
Refer
Making a Check before Starting the Procedure
Check the environment (operating system, backup software, and HBAs) of the server to be
connected to the LT20 S2/LT40 S2/LT60 S2.
- "1.1 Operating Environment" (page 17)
Setting the LT20 S2/LT40 S2/LT60 S2
Perform the settings for the LT20 S2/LT40 S2/LT60 S2.
- "2.1 Settings for SAS Connections" (page 31)
Refer
Refer