Fujitsu ETERNUS LT60 S2 - 4.6 ARCserve Backup Setup

Chapter 4 Setting the Backup Software
4.6 ARCserve Backup
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
65
4.5.2 Notes on Using Windows Server 2019
To use NetVault on Windows Server 2019, ETERNUS LT series Tape Library Driver is required.
Install the Windows Server 2016 device driver (w2k16) in Windows Server 2019.
For the download and the installation procedure of the Tape Library Driver, refer to the following website.
https://www.fujitsu.com/global/support/products/computing/storage/download/
4.6 ARCserve Backup
This section provides notes about the settings that are performed for ARCserve Backup.
4.6.1 Notes on Operation
■ Cleaning tape drives
• ARCserve Backup has a function to automatically clean tape drives. When automatically cleaning tape
drives, use the ARCserve Backup's automatic cleaning function.
• Arcserve Backup can display the number of times each drive has been cleaned. It cannot display the
number of times each cleaning cartridge has been used.
4.6.2 Notes on Using Windows
When Arcserve Backup is used as the backup software, do not use an HP tape driver or IBM tape driver. Use a
dedicated driver instead (this driver is automatically installed during installation of Arcserve Backup).