6.5 Specifying How to Detect Multifeed
fi-5530C2 Image Scanner Operator’s Guide 139
DOCUMENT SPECIFICATIONS FOR ADF
6
6.5 Specifying How to Detect Multifeed
One of the following is selected to detect a multifeed:
• Check overlapping
• Check length
• Check overlapping and length
The following describes what condition is required for each selection:
■ Check overlapping
■ Check length
■ Check overlapping and length
Paper weight
52 g/m
2
- 127 g/m
2
(13.9 lb to 34.0 lb)
Punched holes are not allowed within
35 mm (1.4 in)
of the vertical centerline of the document.
Other paper shall not be glued within
35 mm (1.4 in)
of the vertical centerline of the document.
Document length deviation 1% or less
Punched holes are not allowed within
35 mm (1.4 in)
of the vertical centerline of the document.
Paper weight
52 g/m
2
- 127 g/m
2
(13.9 lb to 34.0 lb)
Document length deviation 1% or less
Punched holes are not allowed within
35 mm (1.4 in)
of the vertical centerline of the document.
Other paper shall not be glued within
35 mm (1.4 in)
of the vertical centerline of the document.
ATTENTION
Multifeed detection by overlap will often mis-detect very thick paper or
plastic document.
When scanning documents like this, please disable the multifeed
detection.
To Next Page
Loading...
