fi-5530C2 Image Scanner Operator’s Guide AP-3
A
■ Settings to Configure on the Scanner
• When you want to use the [Scan] button
There is no specific settings.
⇒ Upon pressing the [Scan] button, the linked application starts up.
•
When you want to use the [Send to] button
Press the [Function] button repeatedly to change a number displayed on the Function
Number Display until the number matches the event number (from 1 to 9) you have set.
⇒ Upon pressing the [Send to] button, the linked application starts up.
HINT
• For example, when you want to execute the [Send to 2] event, change
the number on the Function Number Display to "2".
• Every time you press the [Function] button, the displayed number
changes as follows:
1, 2, 3,...9, C, 1, 2, 3... etc.
Function Numbe
Display
Function
Send to
Scan
To Next Page
Loading...
