Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
141
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Soft Pick Setting When you experience pick errors
from the separator roller slipping on
the paper, or paper jams from
scanning thin papers of small
widths, the symptom may be
improved by bringing down the pick
roller unit and keeping the unit at the
lower position (disabling the Soft
Pick Setting).
It can also be configured from the
operator panel.
Enable / Disable Enable
AutoCrop
Boundary
Specify whether or not to optimize
(round up/down) the fractional part
of the scanned image data.
Normal / Optimize Normal
-
Auto color
Detection
Specify the slice level for automatic
color/monochrome detection.
1 to 255 levels 5
-
Alarm setting Specify whether or not to sound an
alarm when an error such as
multifeed or paper jam occurs.
It can also be configured from the
operator panel.
Disable alarm / Low volume alarm /
High volume alarm
Disable alarm
Jam Detection
outside of
scannable area
when transporting
paper
Specify whether or not to judge the
symptom as paper jam when a
document is skewed and passes
outside the supported scanning
area.
Enable / Disable Enable
Item Description Setting/Value Factory Default SCSI or USB
Connector
VRS board (optional)
connection
: Configurable
-: Not configurable
To Next Page
Loading...
