Fujitsu fi-6400 - Sounding an Alarm When an Error Occurs [Alarm Setting]

Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
162
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Sounding an Alarm When an Error Occurs
[Alarm setting]
Specify whether or not to beep an alarm sound when a paper
jam or multifeed occurs.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, select [Device Setting 2] 
[Alarm setting].
3 Configure settings for alarm.
Disable alarm: No alarm beeps even when an error occurs.
Low volume alarm: Beeps the alarm in small volume when an
error occurs.
High volume alarm: Beeps the alarm in large volume when an
error occurs.
This setting can also be configured from the operator
panel.