Index
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Contents
TOP
18
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
This section describes how to open and close the hopper.
How to Open the Hopper
Open the hopper in the following procedure:
1 Push the upper middle section of the hopper.
2 Bring down the hopper as you support it with your hand.
3 Adjust the hopper extension to the length of the
document.
How to Close the Hopper
Close the hopper in the following procedure:
1 Remove all documents from the hopper.
2 Slide in the hopper extension.
3 If the hopper level has been adjusted, set the hopper back
to the lower position.
Lower the hopper level from the operator panel on the scanner.
For details on how to adjust the hopper level, refer to "1.7 Setting the
Loading Capacity of the Hopper" (page 22).
4 Close the hopper.
Make sure to push the hopper until it locks.
1.4 Opening/Closing the Hopper
To Next Page
Loading...
