Fujitsu fi-6400 - Settings Related to Scanning; Adjusting the Starting Position for Scanning; [Offset;Vertical Magnification Adjustment]

Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
149
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Adjusting the Starting Position for Scanning
[Offset/Vertical Magnification Adjustment]
When the output position of the scanned image is not correct
or the image appears shortened/elongated (vertically), use the
following procedure to adjust the offset and the vertical
magnification for correction.
1 Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page 132).
2 From the listing on the left, select [Device Setting] and
click the [Offset] button.
8.4 Settings Related to Scanning
Normally, you should not have to make any adjustments as the
factory default settings are configured at appropriate values.