Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
150
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
3 Adjust the offset/vertical magnification as necessary.
Offset Setting Description
Unit Select [ADF (front)] or [ADF (back)] as the target
for offset adjustment.
Note that when the connection is via VRS board
(optional), you can only adjust the offset for [ADF
(back)].
Main Adjusts the horizontal (width) offset.
The setting range is from -2 to 3 mm in 0.5 mm
increments.
Sub Adjusts the vertical (length) offset.
The setting range is from -2 to 3 mm in 0.5 mm
increments.
Vertical magnification
Adjustment
Description
Unit The target for vertical
magnification adjustment is fixed
at [ADF].
Vertical magnification
Adjustment (length)
Adjusts the vertical (length)
magnification.
The setting range is from -3.1 to
3.1% in 0.1% increments.
To Next Page
Loading...
