4 - English Important n ot es
Important notes
ImportantnotesNotes
In th is chapter yo u will fi nd information regarding safety which it is essential to
take note of when working with your device.
Safety notes
SafetynotesNote
Please follow the safety
notes provided in the "Safety/Regulations" manual
as well as the safety note
s given below.
When installing and ope
rating the device, please observe the notes
on ambient conditions i
n "
Techn ical data ", Page 40 - English and the
instructions in "
Getti
ng started", Page 7 - English.
Replace the lithium ba
ttery on the mainboard exactly in accordance with the instructions
in the "
Repla cing th
e lithium battery", Page 39 - English chapter.
Caution, component
s in the system can get very hot.
The activities des
cribed in these instructions must always be
performed with the
greatest care.
Repairs to the dev
ice must only be carried o u t by qualified technicians. Incor rec t
repairs could put
the user at gre at risk (electric shock, ha zardous energy e missions,
risk of fire) or cau
se serious damage to the equipment.
Power cable and mains adapter:
The supplied power cable conforms to the requireme nts of the country in
which you purcha sed your device. Make sure that the power cable is approved
for use in the country in w hich yo u intend to use it.
The mains adapter’s power cable should only be connected to a ma ins
socket if the device is connected.
Do not use the mains adapter for other devices.
Use only the mains adapter which is intended for use with the device, see
chapter "
Technical data ", Page 40 - English.
Make sure that the rated curre nt o f the mains adapter is not higher than that of
the power system to which you connect the mains adapter.
ON/OFF switches do not discon nect the device from the mains voltage. To completely
disconnect the mains voltage, remove the power plug from the p ower socket.
Transporting the device
Device,Trans portati onRetransportation
Transport all parts separately in their original packaging or in a packaging which
protects them f rom knocks and jolts, to the new site.
Do not unpack them until all transportation mano euvres are comp leted.
If the device is brought from a co ld e nvironment into the room where it will be used ,
condensation may occur. Before operating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the installation site.
46 Fujitsu Technology Solutions
To Next Page
Loading...
