System expansio ns English - 35
Removing the Power over Ethernet module
Powerover Ethernetmo dule,
► Open the casing (see "Opening the casing", Page 20 - English).
► If a PCI or PCIe board is installed, remove the cross piece and PCI or PCIe
board (see "
Removing the board", Page 38 - English).
1
1
2
► Undo the screws (1).
► Pull the Power over Etherne t module in the direction of the arrow (2) out
of the slot and lift it out of the casing.
► Reinst all the cross piece and the P CI or PCIe board if necessary (see
"
Installing the board", Page 36 - English).
► Close the c asing (see "
Closing the c asing", Page 21 - English).
Ensure that cables are not trapped between the casing and the co mponents.
Fujitsu Technology Solutions 77
To Next Page
Loading...
