System expansio ns English - 29
Installing and rem oving a WLAN module (optional)
You can install an additional WLAN module in your device.
Alternatively, you can install a Power over Ethernet module in the same
slot. You can only install one of the modules.
Installing the WLAN modul
e
WLAN module,
► Open the casing (see "Opening the casing", Page 20 - English).
► If a P CI or PC Ie board is i
nstalled, remove the cross piece and PCI or PCIe
board (see "
Removing th
e board", Page 38 - E nglish).
3
3
1
2
4
► Break t
he cover (1) out of the casing.
► Place the WLAN module in the casing with the compone nt side facing dow nwards and push it
in the direction of the arrow (2 ) through the opening in the back of the casing.
► Secu
re the WLAN module with the screws (3).
► Connect the cable of the WLAN module to the c onn ecto r on the mainboard (4).
► Rei
nstall the cross piece and the PCI or PC Ie board if necessary (see
"
In
stalling the boa rd", Page 36 - Engli sh).
Fujitsu Technology Solutions 71
To Next Page
Loading...
